The excess water left on the ice is squeegeed off with. The tool did the job, despite the lack of clear directions, and saved me a ton of time and money compared to other alternatives. Buy Here A compression sleeve puller is a specialty tool used to remove compression supply stops from copper pipe. With this smart objects removal tool, its possible to identify unwanted objects accurately. It fits behind the compression nut and grips it, then your turn the toggle nut till the nut and ring come off the copper. We recommend using a tool designed specifically to remove compression rings, which is like a bearing puller. Once this connection is made, it’s only a matter of turning the puller handle clockwise until the ferrule is removed from the copper tubing. There are a couple of ways to remove a compression ring, however none of them are easy. This is necessary in order to properly screw the puller handle to one side of the copper fitting, and to screw the old compression nut to the other side of the copper fitting. Unique armless design screws directly into compression nut for fast removal. It took a small bit of jostling, but it did fit. Quick and easy way to remove leaking compression sleeves without damaging walls. To do this, I fit the larger diameter end of the silver fitting into the tools’ copper fitting, so that I could use the combined tool components to push the small diameter end of the silver fitting into the copper tubing. Because my copper tubing was slightly deformed by the existing (old) compression fitting, I needed to persuade the smaller diameter of the silver fitting to fit inside the tubing. The smaller diameter end of the silver fitting must be fitted inside the ½ copper tubing (note that it does not sit up against the outside the copper tubing, it must slide inside the tube). Whether you need to unclog a drain or youre fitting a bathroom suite, with our selection of plumbing tools, youll be able to handle any plumbing project with. The two jaws attached to the puller handle are not required for ferrule removal, but they can be left in place on the tool handle in case you need to use them for pulling a faucet handle later. Both of the fittings that come with this tool (a copper colored fitting and a silver colored fitting) are required to be used with the puller to remove ferrules. I had difficulty understanding how to connect the tool parts for use. I won’t repeat other comments about how to use the device but will point out the one thing that held me up, so that maybe I can save someone else some time. It worked like a charm after I spent about 20 minutes trying to figure out how this little tool works. I recently used this tool to remove ferrules for 4 compression valve fittings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |